Highlights Adhesive Technologies

Additional Information:

• Production Capacity: 1000

• Prevents leakage: It fills all gaps between the mating flange parts and cures into a hard thermoset plastic that fills all surface irregularities providing 100% seal.
• Adapts to flange surface irregularities and scratches up to 0.25 mm.
• Eliminates gasket compression set.
• Reduces inventory cost and complexity as one tube can make many different shapes and sizes of gaskets.
• Provides instant seal.
• Increases the torque capacity of assembled flanges

• LOCTITE 518 is a medium-strength, general purpose gasketing product with excellent contamination tolerance. Ideal for use on casted iron, steel and aluminum flanges.LOCTITE® 518 cures when confined in the absence of air between close-fitting metal surfaces. It is an anaerobic gasketing material designed for use on rigid iron, aluminum, and steel flanged mating surfaces. LOCTITE 518 fills gaps up to 0.25mm and forms a flexible, chemical-resistant seal that will not tear or decay. Parts disassemble easily, even after extended service. Typical applications include sealing close-fitting joints between rigid metal faces and flanges. It is also used as a formed-in-place gasket on rigid flanged connections, e.g. transmissions and motor housings.
• Semi-flexible, medium-strength anaerobic flange gasket
• Easy to automate
• Reduces process costs – eliminates manual assembly of conventional gaskets
• NSF P1 Reg. No. 123758
• For active and inactive rigid metal flanges
• Cures through minor surface contamination
• Adapts to flange surface irregularities and gaps up to 0.25 mm
• Gel-type consistency
• Seals instantly against low pressure
• Reduces inventory costs – no need for large inventory of cut gaskets
• Resists high pressure when fully cured
• No compression set or misaligned gaskets

• LOCTITE SI 5910 is a low strength gasketing product for flexible flanges that has good resistance to oil and joint movement.LOCTITE® SI 5910 is a low strength, silicone-based gasketing product designed for use on flexible flanges with machined or cast surfaces (metal or plastic). It is suitable for gaps up to 1 mm and offers a cure-through volume (in 24 h) of 2.75 mm. Typical applications include stamped sheet metal covers (timing covers and oil sumps).
• For use with flexible flanges
• Good resistance to oil and joint movement
• Can be supplied in cartridges, tubes or rocep cans
• Reduces migration of liquid after application